Grounding Instructions; Extension Cords; Important Notes - Waring Commercial WSV16 Instructions

GROUNDING INSTRUCTIONS

For your protection, the Waring Thermal Circulators machines are
®
equipped with a 3-conductor cordset that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet as shown in Figure 1. If a
grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be used
with a 3-prong plug. Referring to Figure 3, the adapter must be
grounded by attaching its grounding lug under the screw of the
outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician. Never use an adapter unless you are sure it is
properly grounded.
Note: Use of an adapter is not permitted in Canada.

EXTENSION CORDS

Use only 3-wire extension cords that have 3-prong grounding-type
plugs and 3-pole cord connectors that accept the plug from the
appliance. Use only extension cords that are intended for indoor
use. Use only extension cords having an electrical rating not less
than the rating of the appliance. Do not use damaged extension
cords. Examine extension cord before using and replace if damaged.
Do not abuse extension cord and do not yank on any cord to
disconnect. Keep cord away from heat and sharp edges.

IMPORTANT NOTES

CAUTION: To ensure continued protection against risk of electric
shock, connect to properly grounded outlets only.
DO NOT ATTEMPT TO DISASSEMBLE
There are no user-serviceable parts inside the appliance. Do not
attempt to service this product. Do not immerse base in water or
other liquids. A short power-supply cord is provided to reduce the
hazards resulting from entanglement or tripping over a longer cord.
An extension cord may be used with care; however, the marked
4