Zibro P 24 Manuel D'utilisation page 75

J
trOuBle ShOOting
Problem cause
No power supply
The unit does
not function
Water tank indicator is on
In direct sunlight
Windows or doors open,
many people or heat source
The unit does
in room
not seem to
Dirty filter
perform
Air inlet or air outlet blocked
Room temperature lower
than selected value
The unit is
Unit stands uneven
noisy
The compressor Overheat protection probably
does not work activated
Distance too great
Remote control
Remote control signal not
does not func-
detected by control panel
tion
Batteries empty
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs
result in loss of warranty and can endanger the user.
Solution
Connect to a functioning out-
let and switch on
Empty the internal water con-
tainer (refer to Chapter F)
Close curtains
Close doors and windows, or
place an extra air conditioner
Clean filter
Remove blockage
Change temperature selec-
tion
Place on even surface (less
vibrations)
Wait 3 minutes until the tem-
perature has decreased, and
turn on the unit again
Make sure the remote control
is correctly aimed at the con-
trol panel < 5m
Replace the batteries
4
75