Enphase Energy M215 Guide D'installation Rapide page 3

Terminate the Unused End of the Cable
6
a. Remove 60mm of the cable sheath from
the conductors.
b. Slide the hex nut onto the cable.
c. Insert the cable end all the way into the
wire organiser (up to the stop).
hex
nut
d. Attach the cap.
e. Use a tie wrap to attach the terminated cable
end to the mounting rail.
wire
cap
organiser
bend wires down
into recesses of wire
organiser and
trim to length
place cap over
the wire organiser
hold the cap with
the disconnect
tool or a
screwdriver
rotate the hex nut
with your hand or
a spanner until the
latching mecha-
nism meets the
base – do not
over-torque
Connect the Cable to the AC
7
Junction Box
Connect the Engage Cable to the AC
branch circuit junction box. See notes in
Step Details on back.
Complete the Installation Map
8
Peel the removable serial number label
from each microinverter and affix it to the
respective location on the paper copy of
the installation map.
affix
serial
number
labels