Error Signals / Troubleshooting - Storch Digi Dist Mode D'emploi

Addition and subtraction
The single distance, area, volume and indirect length can be added or subtracted by the
addition and subtraction function.
1. Conduct the first measurement.
2. Press the "Plus/Minus" button; the "+" or "-" symbol appears after the battery indica-
tor.
3. Conduct the second measurement.
4. The sum of the measurements is displayed on the bottom line of the screen and
the last measurement results are displayed simultaneously on the upper line of the
screen.
Using a tripod
The use of a tripod is particularly helpful for measuring larger distances. The measuring
device can be screwed onto a commercially available tri-
pod by using the 1/4" thread located on the bottom of its
housing.
• Mount the device on the tripod.
• Set the thread as the measuring reference point by
pressing button 6 (fig. 25).
• Conduct the measurement.
Error signals
which can appear on the LCD display during the measuring process:
Error code Cause
Err001 The reflected laser light is too
intense.
Err002 Out of range; the measuring
range for this device is bet-
ween 0.1 and 50 m.
Err003 The target surface does not
reflect the laser sufficiently.
Err004 The temperature is too high.
(not included)
Solution
Do not direct the laser at a highly
reflective surface; cover the surface
with white paper if necessary.
Conduct measurements within a range
of 0.1 to 50 m.
Select another target surface or cover
it with white paper.
Wait until the device has reached the
permitted operating temperature (-10°
to 50° C)
88
Fig. 25