Storch Digi Dist Mode D'emploi page 81

Note: Replace the batteries as soon as the "Empty" battery indicator appears.
• Remove the batteries from the device if it is not going to be used for a prolonged
period.
• The 4 AAA batteries should all be the same brand and type.
• Do not use a mixture of old and new batteries.
• Remove depleted batteries immediately and dispose of them in accordance with the
local regulations. Never dispose of batteries in a fire.
Switching on/switching off the digital laser distance
meter
1. Press the Power button (1) to switch on the device. The device will automatically
revert to the single distance measuring mode, indicating that it is ready for use.
2. Press the Power button for approx. 2 seconds to switch off the device.
3. If a button is not pressed for 5 minutes, the device will switch off automatically to
preserve battery power.
Changing the measuring reference point:
The default reference point is the rear of the device. By pressing the measuring/refe-
rence point button (6) this setting can be alternated between the tripod socket, the front
of the device, the positioning pin and the rear of the device; the next measurement will
thereby be conducted from the selected reference point.
When the device is switched off the reference point will automatically revert back to the
rear setting.
Changing the units:
Press the unit conversion button (7) to alternate between metres, millimetres, decimal
feet, 1/16 inch increments, decimal inches and 1/16 inch increments, as shown below.
Setting
Metres
Millimetres
Decimal feet
1/16 inch increments
Decimal inches
1/16 inch increments
Distance
Metres
Millimetres
Feet (decimal)
Feet & 1/16 inch
Inches (decimal)
Inches & 1/16inch
81
Area Volume
m m
2 3
m m
2 3
Feet Feet
2 3
Feet Feet
2 3
Feet Feet
2 3
Feet Feet
2 3