Area Measurement - Storch Digi Dist Mode D'emploi

5. To conduct a second measurement press the Read
button again to activate the laser; the first mea-
surement is now displayed in the upper line of the
screen (fig. 6).
6. Aim at the new target.
7. Press the Read button again to conduct the second
measurement.
8. The second length is displayed on the bottom line
of the screen in large digits and the laser beam
switches off (fig. 7).
9. To conduct a new measurement repeat steps 5 to
8.
Note:
After selecting the area, volume or Pythagorean The-
orem measurement mode press the Delete button to
revert back to the single distance measurement mode.

Area measurement

1. Press the Mode button (4) to access the area
measurement mode; the flashing line in the
symbol indicates the length to be mea-
sured (fig. 8).
2. Press the Read button to activate the laser beam;
the laser indicator will flash.
3. Position the device in such a way that the laser is
aimed at the point to be measured.
4. Press the Read button to display the measured
length on the first line of the screen. (fig. 9).
5. The line for the width in the
to flash.
6. Position the device in such a way that the laser is
aimed at the point to be measured.
symbol starts
83
Fig. 6
Fig. 7
Fig. 8
Fig. 9