Operation; Inserting The Batteries - Storch Digi Dist Mode D'emploi

Operation

Your digital laser distance meter is a precision instrument. Please observe the following
guidelines to ensure optimum performance:
• Do not direct the Digi Dist unit towards the sun or other sources of bright light. This
may cause a faulty reading or result in inaccurate measurements.
• Do not operate the device in wet, dusty, sandy or other adverse environments. Such
conditions may damage internal components and impair the accuracy of the mea-
surement.
• If the digital laser distance meter is transferred to a warm environment from very
cold conditions, or vice versa, allow it to acclimatise before use.
• Measuring errors can occur when conducting measurements against transparent
liquids (e.g. water), clear objects (glass) or other similar translucent or low-density
materials.
• Highly reflective surfaces deflect the laser beam and result in faulty measurements.
• Extremely bright surroundings combined with a poorly reflective surface will reduce
the measuring range and accuracy of the device.
• Do not immerse the device in water. Wipe off any dirt using a damp, soft cloth. Do
not use abrasive cleaning agents or solutions. Treat the surfaces of the device with
the same care that you would apply to spectacle lenses or cameras.
• The accuracy of the device must be checked if it has been dropped or subjected to
other mechanical stresses.

Inserting the batteries

(fig. 3)
This digital laser distance meter requires four AAA 1.5 V bat-
teries.
1. Press the catch to open the battery compartment.
2. Insert four new AAA alkaline batteries into the battery
compartment in accordance with the polarity markings.
Pay attention to the correct polarity (+/-)!
3. Close the cover and secure it in place.
80