Attach Lifting Units To The Vehicle Wheels - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

Wheel Ø at different setting positions of the wheel fork
Position 1
Min. 501 mm
Max. 600 mm

10.5.3 Attach lifting units to the vehicle wheels

1. Push wheel fork under the wheel.
2. Switch on main switch.
3. Check or reset the transmission channel. (all lifting units of a
system must be set to the same channel) (→10.6)
4. Briefly raise the wheel.
5. Check the safe uptake of the wheel.
6. Mark the position of the lifting unit on the control and register for
group operation.
Repeat steps 1 to 6 for all lifting units.
126746
Position2 Position 3
570 mm
800 mm
DANGER
Risk of death and injury from damaged tyres
◼
Never lift vehicles on damaged tyres.
◼
Never lift the vehicle on tyres with too low air pressure.
Position 4
801 mm 1001 mm
1000 mm 1200 mm
Operation
Position 5
1201 mm
1300 mm
S 7
HydroLift
99