Deposition Of The Seed; Planting Unit; Rear Covering Wheels - Gaspardo MAGICA 9 Mode D'emploi Et Entretien

ENGLISH

5.5. DEPOSITION OF THE SEED

5.5.1 PLANTING UNIT

In order to ensure that the seeds are all planted at a uniform depth,
a few simple adjustments should be made to the planting unit.
Adjust the seeding depth by changing the height of the side wheels
(1, Fig. 40) using the crank (2, Fig. 40). A numbered scale (3, Fig.
40) enables all of the parts to be adjusted to the same degree.
N.B.: the pointer of the adjustment scale is purely progres-
sive; it does not show a variation in cm on the height of the
side wheels.
Depending on the type of soil to be sown, adjust the compression of
the springs (6, Fig. 41) to either increase or decrease the seeding
element's power of penetration:
Min. 110 Kg
Moving from a notch and the other of the adjustment scale cor-
responds to a variation of the load of approximately 2.5 kg.
N.B.: the adjustment scale index (7, Fig. 41) is purely pro-
gressive and does not, under any circumstances, indicate a
variation in kilograms.

5.5.2 REAR COVERING WHEELS

The rear set-up of the seeding elements is of considerable impor-
tance in quality sowing (Fig. 42):
A) Rubber «V» shaped (1 inch) press wheels (Ø 300 x 25 mm);
B) Rubber «V» shaped (2 inch) press wheels (Ø 320 x 50 mm);
C) Iron «V» shaped press wheels.
These elements are crucial to the covering of the seeds after they
have been sown.
They should therefore be suitably adjusted according to the type
of seed and type of ground:
- change the position of the rear wheels on their support as shown
in the diagram in Figure 43 (D-E);
- using the handle (4, Fig. 40), adjust the pressure of the rear
inclined wheels for closing and packing the seed furrow (5, Fig.
40).
If the covering wheels («NO», Fig. 43) are not aligned with the
seed furrow, proceed as follows:
- Raise the planting unit.
- Loosen the clamping screw (6, Fig. 43).
- Rotate the cam (7, Fig. 43) by 180° in a clockwise direction to
move the covering wheels to the right, and in an anticlockwise
direction to move them to the left.
- Visually centre the wheels with the furrow opening disc of the
seeding element.
NOTE: After centring the covering wheels, ensure that the wheels
are all resting on the ground at the same time («SI», Fig.
43) and with the same pressure.
- After completing the adjustments, tighten the clamping screw.
66 - EN
USE AND MAINTENANCE
>>> Max. 140 Kg
1
fi g. 40
fi g. 41
A
fi g. 42
D
E
fi g. 43
-
2
3
4
7
6
C
6
7
cod. G19503301
5
B