Atag Descale Notice D'installation page 12

DAYS BETWEEN REGEN
SET "7"
REGEN TIME HOUR
SET "21":00
REGEN TIME MINUTES
SET 21:"00"
d) Operating mode, cycle time, capacity, reserve type settings,
service alarm – installer and manufacturer setting
"SOFTENING"
SET
FILL
SET "1,10"
12
Set up number of days between two regenerations.
°F
Default setting is "14". Maximum number of days is "28"
"Off" display indicates there is no forced regeneration.
Push on
Set up time of regeneration (Hour). Number flashes.
By pushing on
regeneration time
Push on
Set up time of regeneration (Minute). Number flashes.
By pushing on
regeneration time
Push on
different parameters.
Push and hold for 3 seconds
TYPE
Choice of operating mode "SOFTENING"
By pushing on
"FILTERING" mode
In this brochure, we only describe "SOFTENING" mode.
Push on
Set up the number of kg for cycle 1 (cycle definition in
item e)
KG
Push on
to go to the next parameter
or , adjust to the requested
to go to the next parameter
or , adjust to the requested
to go to the normal mode. Scrolling the
or , we can switch to
to go to the next parameter
to go to the next parameter
and