Table des Matières
Publicité
Power
After the unit is plugged in and the switch at the side of the control unit is pressed.
Press the
button and in the display appears C0.
Press another time the
starts heating.
To change the Power press first the Power button , in the display C5 is flashing. Now
there is ca 5sec time to change the temperature or the display will return to C5.
By pressing the
/
C5: 250°C Grilling on highest power
C4: 210°C Grilling on middle power (e.g. fir tender meat)
C3: 150°C Grilling on low power (e.g. fish or vegetable)
C2: 120°C low temperature
C1: 80°C keeping warm for dishes
If there is not any pressing of the
must be pressed again to change it the power level.
Timer
Press the Timer button
change the Time or the display will return to the adjusted power level.
By pressing the
button the time can be changed.
Button pressed only short time: 1 Minute steps
Button pressed longer time: 10Minute steps
Max adjustable time 99 minutes
When the LED in the display is flashing, the timer is working.
In the display you can see the Time and the adjusted Power changing. After the time
run out the appliance will switch off and a beeping sound can be heard.
Residual heat
After a certain temperature is reached the residual heat light
The residual heat light will flash after the unit is turned off until the plate cooled
down. Notice: The appliance is equipped with a cooling fan. Never unplug the ap-
pliance immediately after the unit is switched off. Please wait until the residual heat
light turned off. With this damage of the electronic can be avoided.
Cleaning and maintainance:
∙
The device should be cleaned after each use
∙
Unplug the device
∙
The device should cool down a little. It can be cleaned easier when it is not that
hot.
∙
Never immerse the device in water!
∙
Use a humid cloth with a little bit of detergent to clean it.
∙
Burned in residues can be sprayed with an oven cleaner and should stay on the top
for at least 1h. The solved residues can then be wiped away with a damp cloth.
24
button and C5 will appear in the display, the appliance
buttons the heating power can be changed.
/
buttons within 5 sec, then the power button
, in the display „00" is flashing. Now there is ca 5sec time to
will be switched on.
Publicité
Table des Matières
