Panasonic ES-RT87 Mode D'emploi page 16

Masquer les pouces Voir aussi pour ES-RT87:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
Notes
• The water and detergent will mix after cleaning begins,
making cleaning liquid.
• If "AUTO" mode cannot be selected or the STATUS lamp
glows for 5 seconds when the SELECT button is pressed,
the cleaning liquid needs to be replaced. Replace the
cleaning liquid.
• When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on
beard thickness and the ambient temperature.)
• Use the detergent within approximately 6 months after
opening the package. When 6 months have passed,
discard the cleaning liquid, and then pour new water and
detergent into the cleaning liquid unit.
• Replace the water and detergent at the same time.
Otherwise the cleaning function may deteriorate.
• Only use self‑cleaning recharger detergent for Panasonic shavers.
►Cleaning the shaver
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
1
1
Insert the appliance plug
[CN] into the self-cleaning
recharger [B].
2
2
Pull up the arm until it clicks.
3
3
Remove the protective cap
[A1] and then attach the
shaver.
4
4
Push down the arm until it
clicks.
16
5
5
6
6
2
Charge
4
3
5
AUTO
1
Plug in the adaptor [CK] into a household
outlet.
• Turn the shaver off before attaching.
• Check that the system outer foil is not deformed or
damaged when you are attaching the shaver.
• Put shaver into the self‑cleaning recharger with the
trimmer handle retracted. If the trimmer handle is not
retracted, it might scratch the cleaning tray.
Press the SELECT button [BJ] to select the
mode.
• The "Charge" mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode
changes from "AUTO"
"Charge".
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this
case, perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as
the cleaning liquid may spill causing a malfunction.
Mode
Time required (guide)
Charge
0 to 60 min
Clean/Dry
10 min/350 min
• It is not possible to change the mode after
"AUTO" mode has started.
Charge
0 to 60 min

Publicité

Table des Matières
loading

Table des Matières