Start-Up And Operation Of The Heat Pump; Initial Display - Procopi CLIMEXEL HC-HH Série Notice D'installation Et Conseils D'utilisation

VII. Start-up and operation of the heat pump
Once the previous steps have been correctly carried out
and filtration is running, the heat pump can be switched on.
Protective glass cover
To open the translucent cover, pinch the two tabs together
while simultaneously lifting the cover upwards.
Close the control panel cover after use to protect it from
humidity.
See
See VII.4, VIII.2. If you press this button
VIII.2
accidentally, press it again to revert to the

initial display.

VII.1- Initial display:
When the heat pump is correctly wired and powered up, the control panel will display the pool water temperature:
- The 3 large figures in the upper left hand corner indicate the temperature of the water at the heat pump water inlet.
The unit of temperature is displayed on the right.
- The 3 figures on the bottom left indicate the water temperature at the heat pump outlet
This display can be modified afterwards (see paragraph VII.4 ).
Caution: the screen will remain black if no current arrives at the heat pump or, in the case of a tri phase heat
pump, if the phases have been inverted .
See
VIII.2
See VII.2, VII.3,
See
VII.4, VIII.2
VII.2
See VII.3, VII.4, VIII.2. If you
press this button accidently, the
initial display will return after 5
seconds.
2009/01 - Indice de révision : C - Code : 0033385
39/48
SeeVII.3,
VII.4, VIII.2