Procopi CLIMEXEL HC-HH Série Notice D'installation Et Conseils D'utilisation page 31

HC-HH series CLIMEXEL heat pumps draw ambient air in through the evaporator and expel air out through the fan
grill(s). The nominal air flow rates are as follows :
HC-HH 62 M
Number of fans*
Nominal air flow
rate 700
(m3/h)
Fan motor 850
technical data
0.132
(Rotations/
mn-kW-A) 0.94
* Each fan is fitted with a single phase motor 50 Hz 230V
Be very careful not to hinder or block the air flow.
To ensure that the air can flow freely, minimum distances (see the figures below) must be respected between the
various sides of the machine and the obstacles surrounding it (partitions, walls, hedges, etc.):
The heat pump must be installed and solidly attached to a rigid support (concrete slab, etc), the dimensions of which
must at least be equal to the footprint of the machine.
HC-HH 62 M
Weight (kg) 59
Dimensions
(Width x
820x280x590
depth
x height)
To attenuate any vibrations, "silent-blocks" can be inserted under the feet of the machine before is it fixed in position.
The support should be very slightly sloped (a slope of 1 to 2% will suffice) towards the corner where the conden-
sate drainage hole is situated, condensates will drip from the bottom of the machine (under the part containing the
electronics).
The condensate drain union supplied with the heat pump can be clipped into the drainage hole under the machine.
HC-HH 72 M HC-HH 92 M
1 1
2200
850
0.17
0.76
HC-HH 72 M HC-HH 92 M
95 108
905x405x762 905x405x965
HC-HH 102 M HC-HH 122 M
HC-HH 102 T HC-HH 122 T
1 1
3100 3100
850 850
0.17 0.17
0.76 0.76
HC-HH 102 M HC-HH 122 M
HC-HH 102 T HC-HH 122 T
118
905x405x965 905x405x1270 905x405x1270 905x405x1270
2009/01 - Indice de révision : C - Code : 0033385
31/48
HC-HH 152 M
HC-HH 172 T
HC-HH 152 T
2 2
4400 6200
850 850
0.17 0.17
0.76 0.76
HC-HH 152 M
HC-HH 152 T
129 140
2
6200
850
0.17
0.76
HC-HH 172 T
143