Fully Recessed Installation - Napoleon Entice 36 Serie Mode D'emploi

installation
EN

3.4.2 fully recessed installation

Remove side trims and top trims (Fig. 3-11).
A.
Remove the power cord and complete hardwiring (see "hardwiring installation" section).
B.
Remove side holding brackets by removing the screws from inside the appliance (Fig. 3-12). Reinstall the
C.
screws after removing from outer trim,
Insert the appliance into the rough framing.
D.
Secure two screws (supplied) to the stud through the two slot holes from each side of the appliance (Fig.
E.
3-13).
Side Holding
Bracket
Reinstall side holding brackets.
F.
Install media (see "crystal ember installation" section).
G.
Reinstall front glass (see "glass removal / installation" section).
H.
18
W415-2782 / B / 07.20.20
For illustrative purposes
only. Installation may vary
by model size.
Framing hidden
for clarity.
Fig. 3-12
Fig. 3-11
Repeat on
opposite side.
Framing hidden
for clarity.
A x 4
Fig. 3-13