Maintenance; Monitor Maintenance; External Module Maintenance; Technical Data - SOMFY Origin io Mode D'emploi

EN
Operating principle of the addresses and extensions of the monitors
The configuration of each monitor determines how it can communicate with the other monitors of the installation, which is
why it is important that your installer completes the guide at the beginning of these instructions and that your keep it handy.
Switch 10 - SW1 = ON
Switch 10 - SW1 = OFF
Note: a monitor configured with SW1 = ON cannot call another monitor in the same house but can be called by a monitor in
the same house configured with SW1 = OFF.

8.1 Monitor maintenance

The monitor should be cleaned using a so , dry cloth; do not use solvents.
Before cleaning, switch off the equipment.

8.2 External module maintenance

The external module should be cleaned using a so , dry cloth; do not use solvents.
Before cleaning, switch off the equipment.
Power supply
Screen
Nominal current
Operating temperature
Frequency range and max power used for the io control
10
The monitor can call the
monitor(s) of another house.
Note: communication can
be established between two
monitors at the same time.
The monitor can call the
monitor of the house.
Note: communication can
be established between two
monitors at the same time.

8 MAINTENANCE

9 TECHNICAL DATA

Bus line
7'' - 800 x 480 mm
0.8 A
-10/+50°C
868.700 MHz - 869.200 MHz
e.r.p. <25 mW
Press the number of times
corresponding to the main address
(Adr.) of the house to be called:
House with Adr. = 1, press once
House with Adr. = 2, press twice
Note: all the monitors configured to
SW1 = ON ring when the house is
called.
Press the number of times
corresponding to the extension (Ext.)
of the monitor to be called:
Monitor with Ext. = 1, press once
Monitor with Ext. = 2, press
twice
etc.
Copyright © 2016 Somfy SAS. All rights reserved.