Device Description; Preparation; Initial Startup; Operation - Kärcher NT 65/2 Ap Me Mode D'emploi

Device description

Illustration A
Electrodes
1
Suction hose
2
Push handle
3
Suction head lock
4
Dirt receptacle
5
Removing the
6
Steering roller
7
Suction hose port
8
Chassis
9
Floor nozzle
10
Suction pipe
11
Main switch
12
Carrying handle
13
Filter cover
14
Filter dedusting button
15
Hose holder
16
Angle piece
17
Rest for floor nozzle
18
Suction pipe holder
19
Mains cable
20
Holder for crevice nozzle
21
Cable clips
22
Type plate
23
Filter dedusting
24
Flat fold filter
25
Colour coding
 Control elements for the cleaning process are yel-
low.
 Control elements for maintenance and servicing are
light grey.

Preparation

1. Unpack the device and install the accessories.
Illustration B

Initial startup

ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the flat fold filter when vacuuming.
Dry vacuuming
 An additional paper filter bag can be used when vac-
uuming fine dust.
Installing the paper filter bag
1. Unlock and remove the suction head.
2. Connect the paper filter bag.
Illustration C
3. Fit and lock the suction head.
10
Wet vacuum cleaning
Note
The flat fold filter (cellulose) with the order number
6.904-283.0 included in the scope of delivery is not rec-
ommended for regular wet vacuum cleaning.
Installing the squeegees
1. Remove the brush strip.
Illustration D
2. Install the squeegees.
Removing the paper filter bag
 The paper filter bag must always be removed when
vacuuming wet substances.
 It is recommended to use a special filter bag (wet)
(see filter systems).
WARNING
Improper disposal of waste water
Environmental pollution
Observe the local waste water treatment regulations.
 We recommend not using the "Semi-automatic filter
dedusting" function button when vacuuming wet dirt
with the crevice nozzle or upholstery nozzle (option-
al) or when sucking mainly water out of a container.
 The device switches off automatically when the
maximum fluid level is reached.
 When vacuuming non-conductive liquids (e.g. drill
emulsion, oils and grease) the device does not au-
tomatically switch off when the container is full. The
filling level must be continuously monitored and the
container emptied on a timely basis.
 On completion of wet vacuum cleaning: Clean the
flat fold filter using the dedusting function. Clean the
electrodes with a brush. Clean the container with a
moist cloth and dry it off.
The suction hose is equipped with a clip system. All ac-
cessory parts with a nominal width of 40 mm can be
connected.
Illustration E
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Semi-automatic filter dedusting
Note
Actuating the semi-automatic filter dedusting every 5-10
minutes extends the working time of the flat fold filter.
Note
The semi-automatic filter dedusting can only be
switched on when the device is switched on.
1. Press the semi-automatic filter dedusting button 5x.
The flat fold filter is then cleaned by a blast of air
(pulsing noise).
Switching off the device
1. Press the semi-automatic filter dedusting button 5x.
2. Switch off the device at the main switch.
3. Pull out the mains plug.
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of the device and
clean with a moist cloth.
English
General
Clip connection

Operation