dirna Bergstrom bycool blue line FLAT Instructions De Montage page 16

FLAT
EN
Recommendations
For assembly
• Before starting the assembly read the instructions and
follow them during the installation process.
• Use suitable tools for each operation.
Electricity
• Switch off the ignition key.
• Disconnect the battery before starting the
assembly.
• Secure the connection of the electrical components
by checking that they fit correctly.
! Warning
When installing the evaporative unit in the ceiling, protect
the upper part of the cabin with a cloth or sheet to prevent
scratching. When installing Bycool Flat in the ceiling,
bear in mind that cabins are normally fitted with a hatch
and have a structure which can withstand the weight of
the unit. However, if this is not so and it is necessary to
open up the ceiling, or should the hatch material not be
sufficiently resistant (e.g. fibre, plastic, etc) the installer
must decide, under his sole responsibility, on the need
to reinforce the ceiling in order to prevent deformation,
breakage, incoming water, etc, and use the means
necessary to this end.
Set of Torx Keys
Set of Allen Keys
Ratchet head 13, 15, 19
Scissors
Tape measure
Riveter
Drill bit 9
Drill
Ratchet wrench 1/4
Documentation included
Assembly instructions
User´s manual
Troubleshooting
Piezas suministradas
Warranty
!
Part no. 17 from the List of Parts Supplied must be
replaced every 12 months.
!
dirna Bergstrom, s.l. will not be held responsible
for any faults arising from inappropriate handling or
installation of the equipment, or due to modifications
or replacements carried out without our written
authorisation.
!
See warraty procedure for the product included in
Troubleshooting.
!
See the equipment User´s Manual for the correct
operation of the remote control and the control
panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
16
Tools
220.AA3.5370
220.AA7.0003
220.AA7.0004
220.RE0.0165
220.AA1.0017
! Warnings
®