Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Log splitter with 400 V 3~
Make sure that the motor turns in the correct direction
(see motor arrow), because operation in the wrong
direction damages the oil pump.
8
Hydraulics
Never operate the machine in the event of any possible
danger from hydraulic fluid.
Ensure that the machine and working area are clean and
free of oil.
Danger of slippage or fire!
Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see "Care and
maintenance")
Capacity: 4.0 litres
W
o
r
k
i
n
g
w
i
t
W
o
r
k
i
n
g
w
i
SAFETY INSTRUCTIONS
additional
The log splitter may only be operated by a single person.
The machine may only be operated by persons over the
age of 18 years, and who have read and understood
these operating instructions.
Wear protective equipment (safety goggles/mask, gloves,
safety shoes) to protect yourself from possible injury.
Never try to split logs containing nails, wire or other
similar objects.
Already split wood and wood chips create a dangerous
working area. The operator may stumble, slip or fall.
Always keep the working area neat and tidy.
Never place the hands on or near any moving parts of the
machine when it is switched on. Maintain a safe distance
from the log, the ram and the wedge in order to protect
your hands from injury.
The machine should only be used for splitting logs with a
maximum length of 1050 mm.
Check before splitting if the splitting column has
been sufficiently lubricated to allow its trouble-free
retraction and extension.
You can change the
direction by placing a
screwdriver in the slot
provided in the plug
collar, and adjust the
correct direction by
moving to the left or
right applying slight
pressure.
h
t
h
e
l
o
g
s
p
l
i
t
t
e
t
h
t
h
e
l
o
g
s
p
l
i
t
t
e
What type of logs can I split?
Size of logs
Length:
Diameter:
The log diameter is a recommended guideline figure,
because:
− thin logs can be difficult to split if they contain knots or if
the fibres are too strong.
− logs with a diameter of over 300 mm can be split if the
fibres are smooth and open.
Do not try to split green logs. Dry logs are much easier to
split, and do not cause jams as often as green (damp) wood.
Operation
Two-hand operation
Never operate the log splitter with two people.
Never block the control handles (clamping claws).
1. Press the green switch on the electric motor. Wait a few
moments until the motor has reached its operating
revolutions and the required pressure has been built up in
the hydraulic pump.
with threephase motor (400 V 3~), because operation in
the wrong direction damages the oil pump.
for at least 15 min. in neutral to heat up the oil.
r
2. Place the log
r
on
splitter table.
the logs in the
direction
the
fibres.
3. Hold the log
tight with the
clamping
claws.
4. Press
operating handles down simultaneously:
The splitting blade falls down and splits the log.
5. Release the two control handles, the splitting blade
returns to its initial position.
splitting blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum
dimensions. Ensure also that the logs are cut straight and
square.
Place the log properly on the log splitter, so as not to cause
any risk of stumbling or falling to the operator.
18
max. 1050 mm
min. 100 – max. 300 mm
Check the direction of the motor in the log splitter
At temperatures below –5° C, let the log splitter run
the
log
9
Only split
of
wood
both
If you only release one control handle, then the
Publicité
Table des Matières
