Testing, Warranty And Liability; Safety Rules; General Notes On Safety And For The User; Conditions Of Installation And Normal Operation - FPZ SCL R20-MD MOR IE2 Instructions

8.5

TESTING, WARRANTY AND LIABILITY

Testing and inspection
•
The entire unit is sent to the customer prearranged for installation, after passing the tests and inspections required by the
manufacturer, in conformity with the current regulations.
Warranty
•
Warranties are defined in the general terms and conditions of sale.
Liability
•
FPZ S.p.A. cannot be held liable for operation faults or generic failures caused by improper use of the unit or operations carried out
by persons not authorised by FPZ S.p.A.
9

SAFETY RULES

9.1

GENERAL NOTES ON SAFETY AND FOR THE USER

The instructions listed below must be read carefully and become a fundamental part of daily
procedures in the use and maintenance of all the equipment, in order to prevent any kind of
accident, injury or damage.
•
The unit must be used only and exclusively for its intended purpose and in accordance with that contractually established with FPZ
S.p.A.
•
All installation, commissioning and maintenance operations must be carried out exclusively by qualified personnel.
•
Use appropriate PPE such as boots, gloves, goggles and work clothes.
•
Do not try to start the unit until its operation is clearly understood.
•
If any doubts arise after having read this manual carefully and completely, contact FPZ S.p.A.
•
Make sure all personnel involved in the use of the unit are informed regarding all the safety requirements.
•
Before starting the unit, the operator must check the efficiency of the safety devices and for any obvious defects in the unit. In case
of any defects, immediately notify FPZ S.p.A.
•
Check the proper operation of all the safety devices every day.
•
The safety devices must never be removed or disabled.
•
During maintenance or repair work it may be necessary to exclude some safety devices from the service. This operation must be
carried out by authorised personnel.
•
Never attempt rash solutions.
•
Do not modify the electrical connections on the unit.
•
Do not wear clothes, jewellery or accessories that can get caught in moving parts.
•
Always keep the area around the unit free of obstructions.
•
Pay attention to all danger and caution signs placed on the unit.
•
Always apply and enforce the safety rules; in case of any doubts, always consult this manual before acting.
Non-compliance with the unit's intended use can cause serious accidents
The unit must only be started:
•
In conformity with the purposes of use, specified in "FORESEEN USE", respecting the rules on transport and handling.
•
Respecting the values given in the "SPECIFICATIONS" and the electric motor RATING DATA.
9.2

CONDITIONS OF INSTALLATION AND NORMAL OPERATION

Startup and operation must occur only under the following conditions:
FPZ-MI-R-MD-MOR-GOR-IE2-15-R03
R-MD GOR
30 / 119
R-MD MOR