Installation With Adhesive Strips; Operation; Set Value Balance (Offset) - Altech ALEC-42090 Mode D'emploi

Table des Matières

Les langues disponibles

5.2.3

Installation with adhesive strips

Depending on the ground, installation can be performed using the supplied dou-

ble-sided adhesive tapes. Installation is possible on different grounds, as e. g. ma-

sonry, furniture, tiles or glass.

1. Select an appropriate installation position.

If the installation is done with adhesive strips, the installation surface must

be smooth, level, undamaged, clean, and free from grease and solvents.

1. Remove the protective foil from one side of the adhesive strip.

2. Fix the adhesive strip on the back side of the installation bottom in the recesses

provided for this (see page 6 fig. 2c).

3. Remove the protective foil from the other side of the adhesive strip.

4. Align the device horizontally to the desired position and press it on.

The target temperature is set manually on a scale from 0 to 5 by turning the setting

wheel (E) to the left or to the right.

6.1

Since the temperature is measured at the room control unit, it may be warmer or

cooler in another position in the room. The deviation can be corrected via a set

value balance of -2 K to 2 K in 0.5 K increments.

5. Remove setting wheel (E). There is a scale for the balance on the inside of the setting

wheel (E) (see page 7 fig. 5)

6. Insert the set point correction limiter (F) to the desired place in the setting wheel (E).

Table des Matières

Table des Matières