Lcd Monitor Cabling Diagram - Wacom DTU-1931 Guide D'installation Et Manuel D'utilisation

LCD MONITOR CABLING DIAGRAM

C
AUTION
Make sure your video card has a VGA or DVI connector, and that you correctly set the DVI/VGA switch
for the video connector you are using.
Do not attach the USB data cable until instructed to do so.
VGA or DVI
video card
Rear panel
of computer
To AC outlet
C
AUTION
Do not connect or disconnect the video or power cables while the DTU-1931 or your computer are
turned on – this can damage the display or computer video card.
Use only the power adapter that came with the DTU-1931; use of an improper power adapter may
damage the unit.
Make sure that the display refresh rate does not exceed 75 Hz.
– A –
DVI/VGA switch
– B –
Analog RGB cable
or
DVI to DVI cable
– D – Power adapter
Analog (VGA)
Digital (DVI)
– C –
DC input
Use the DVI-I port to
OUT
connect a second device,
such as a projector or
monitor, that mirrors the pen
display.
Fully install the DTU-1931
hardware and software
before connecting a
projection device to the unit.
DVI
IN
Installation
Page 13