Install Backsplash; Install Wood Mounting Strip; Install The Hood - Broan-NuTone RANGEMASTER RM60000 Série Mode D'emploi

4. INSTALL BACKSPLASH

(OPTIONAL) RMP Series
Backsplash must be installed before the hood shell because the hood shell covers
the backsplash top mounting screws. In order to be able to install the backsplash,
make sure you have at least 18" (457 mm) clearance between bottom of hood and
range control panel or cooktop. (Refer to instructions included with backsplash.)

5. INSTALL WOOD MOUNTING STRIP

Measure and mark a level line on wall above cooktop location for the wood mounting strip
(see illustration below and under step 2). Use #10 - 2" flat head screws to secure the
mounting strip to the drywall. Make sure to hit the wall studs. (See figure below.)
Due to the weight of this hood, ensure that the wood strip is attached to all of
the available wall studs (2 studs minimum for the 30" hood, more as hood
width increases); not into the drywall alone.
1. Drywall
2. Wood Mounting Strip
3. Flat Head Screw
4. Wall Anchor Location
5. Outline of the Back of the Hood
6. Wall Studs

6. INSTALL THE HOOD

Rest the back cavity of the hood on the wood mounting strip.
Hold the hood until it is completely secured to the wood mounting strip.
Secure hood to wood strip
with (4) screws #8 - 3/4" (for
30" and 36" width hoods) or
(6) screws (for 42" width
and wider hoods) provided
at locations shown. Drill (2)
3/16" size holes into the
drywall for wall anchors
through the existing holes in
the inside hood back in the
locations shown. Then install
the two wall anchors and
attach the hood to these
anchors with the remaining
#8 - 3/4" screws and the
(2) washers provided.
CAUTION
CAUTION
Top of hood (inside view)
Mounting Screw Locations
Wall Anchor Locations
HD0064
- 7 -