Select Blower Option And Install Ductwork - Broan-NuTone RANGEMASTER RM60000 Série Mode D'emploi

1. SELECT BLOWER OPTION AND INSTALL DUCTWORK

Either an interior or exterior blower may be used with this hood. The RM60000
Series hood must be installed with blower models RM325H, RM326H, 331H,
332H, 335 or 336 only. Other blowers cannot be substituted. (Blowers sold separately).
NOTES:1. The 331H, 332H, 335 or 336 exterior blower MUST BE installed with the
rough-in kit model 332KR (sold separately).
2. In addition to the blower models listed above, this hood is also compatible
with older internal blower versions 325H ans 326H. However, discard
the installation instructions included with those blowers and and contact
our technical suppport to obtain replacement instruction.
Plan where and how the ductwork will be located.
Install proper-sized ductwork, transition(s), elbow(s), and roof or wall cap for the
type of blower you are using.
ROOF CAP
DECORATIVE
FLUE
(305 mm)
or SOFFIT
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0024A
MODEL RM325H SINGLE BLOWER
TYPICAL DUCTWORK
EXTERIOR BLOWER
DECORATIVE
12"
FLUE
or SOFFIT
(305 mm)
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0026A
MODEL 331H, 332H, 335 OR 336 EXT.
BLOWER TYPICAL DUCTWORK
7" (178 mm)
ROUND DUCT
12"
WALL CAP
7" (178 mm)
ROUND
ELBOW
10" (254 mm)
ROUND DUCT
10" (254 mm)
ROUND ELBOW
EXTERIOR
BLOWER
332KR
ROUGH-IN KIT
(see page 4)
ROOF CAP
DECORATIVE
FLUE
(305 mm)
or SOFFIT
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0025A
MODEL RM326H DUAL BLOWER
TYPICAL DUCTWORK
- 5 -
10" (254 mm)
ROUND DUCT
WALL CAP
12"
4-1/2" x 18-1/2"
to 10"
(114 x 470 to
254 mm) ROUND
TRANSITION
(see page 4)