Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE HOOD
BLOWER
RETAINING
WHEEL
RING
SECTIONS
MOTOR
SLOTS
Non-Ducted Installations Only: Require a Performance Ring
10
to be attached to the blower wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side to side and
applying a slight force to pull wheel from motor. Remove
Retaining Ring if necessary.
2. Slide the ring onto the Small Diameter End of the wheel
and down to the Stop Edge of the wheel.
3. Reassemble wheel to motor. Make sure Tab on wheel fits
into one of the Motor Slots.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press
Sections into place if necessary. Make sure wheel turns
freely.
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
Remove appropriate Duct Knockout(s) from top or back of
11
hood.
TAB
SMALL DIAMETER
END
RING
STOP
EDGE
PREPARE THE HOOD
TIES
SCREW
METAL STRIP
PLATE
Horizontal Discharge Only: Remove the Plate in front of the
12
horizontal discharge knockout. Cut the Ties, lift plate out,
and discard plate. DO NOT REMOVE the Metal Strip held
in place with two Screws.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
13
3¼" x 10" Ducted Discharge Only: Remove Tape from damper
flap and attach Damper/Duct Connector over knockout
opening with screws removed in Step 4 under "PREPARE
THE HOOD" . Make sure damper Pivot is nearest to Top/Back
Edge of hood.
NOTE
Damper/Duct Connector can be installed up to 1-inch
on either side of hood center - to accomodate off-center
ductwork. In extreme off-center installations, one end of
the duct connector may need to be trimmed to clear the
electrical cable clamp.
ALLURE
QS2 SERIES
®
RANGE HOOD
Page 4
TOP/BACK
TAPE
EDGE
DAMPER/
DUCT
CONNECTOR
(Vertical
discharge
position shown)
Publicité
Table des Matières
