H.Koenig CAVCD53 Manuel D'utilisation page 11

SELECT THE TEMPERATURE
Your wine cellar has one single compartment. The temperature can be chosen between 5°C and 22°C (40° and 72°F). It is
recommended to set the temperature in the lower of 12°C to 18°C (55-64°F) range which is ideal for storing red wines and
to adjust to between 5 and 12°C (40-55°F) range suitable for champagnes and white wines.
Description of the product features
1) Control panel
o The control panel is located at the interior of the appliance, it is very easy to set the temperature of the appliance and
see what temperature the appliance is set to.
2) Interior light
o The wine cooler has an interior light. The light can be switched on and off by using the light control button.
3) The wine cooler shelves
o The shelves are fully adjustable to suit various wine bottle shapes and sizes.
o To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out of the rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves are designed with an emergency
stop to prevent them being removed too far when loaded.
Using Your Wine Cooler
Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information contained in the installation
instructions.
o After delivery, wait for four hours before connecting the appliance to your mains supply. This will allow any refrigerant
gasses that may have been disturbed during the transportation process to settle.
o The outside of the appliance and the removable accessories contained within it, should be cleaned with a solution of
liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved in lukewarm water.
The interior and accessories should be thoroughly dried, after the cleaning process has been completed.
o There can be an odour when you first switch on the appliance. It will lessen as the appliance starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has been turned off
for a long time, there could be a few degrees variance between the temperature you select and the one indicated
on the LED display. This is normal and it is due to the length of activation time. Once the wine cooler has been
running for a few hours everything will be back to normal.
o When you first switch on the appliance, the compressor will run continuously until the wine cooler reaches a cool
enough temperature.