Black+Decker rechargeable batteries. Any other uses may result in risk of fire,
electric shock or electrocution.
• do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge) for
safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. When using more than one extension to make up
the total length, be sure each individual extension contains at least the minimum wire size.
Recommended Minimum Wire Size for extension cords
total length of cord
25 ft.
7.6 m
15.2 m
Wire Size AWG
18
• do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• do not mount charger on wall or permanently affix charger to any surface. The
charger is intended to use on a flat, stable surface (i.e., table top, bench top).
• do not operate charger with damaged cord or plug — have them replaced immediately.
• do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorized service center.
• do not disassemble charger; take it to an authorized service center when service or repair
is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.
• disconnect the charger from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
• NeveR attempt to connect 2 chargers together.
• the charger is designed to operate on standard household electrical power
(120 volts). do not attempt to use it on any other voltage.
fuNctIoNAl deScRIPtIoN
1. Variable speed switch
2. Forward/reverse button
3. Torque Adjustment Collar
4. Keyless Chuck
5. Battery
6. Battery release button
7. Charger
8. Screwdriver bit holder
50 ft.
75 ft.
22.9 m
18
16
7
100 ft.
125 ft.
30.5 m
38.1 m
16
14
4
3
5
5
150 ft.
175 ft.
45.7 m
53.3 m
14
12
1
6
2
8