ENGLISH
NOTE: When following this procedure from
step1 to step 2, the filter system will be removed;
when following it from Step 2 to Step 1, the
filter system will be installed.
Remarks:
• Inspect the filters for blocking after every time
the dishwasher has been used.
• By unscrewing the coarse filter, you can
remove the filter system. Remove any food
remnants and clean the filters under running
water.
NOTE: The entire filter assembly should be
cleaned once a week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use
a cleaning brush. Reassemble the filter parts
as shown in the figures on the last page and
reinsert the entire assembly in the dishwasher,
positioning it in its seat and pressing downwards.
WARNING!
When cleaning the filters, don't knock on them.
Otherwise, the filters could be contorted and
the performance of the dishwasher could be
decreased.
GB-40
Caring for the Dishwasher
OpenThe control panel can be cleaned by using a
lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish
wax.
Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door,
you should use only a soft warm,
damp cloth.
To avoid penetration of water into the door lock
and electrical components, do not use a spray
cleaner of any kind.
WARNING!
• Never use a spray cleaner to clean the door
panel as it may damage the door lock and
electrical components.
• Abrasive agents or some paper towels should
not be used because of the risk of scratching or
leaving spots on the stainless steel surface.
ENGLISH
GB-41