Using Your Dishwasher; Loading The Salt Into The Softener - FAR LVIF1119A++49M Manuel D'utilisation

ENGLISH

USING YOUR DISHWASHER

Inside Outside
1. Set the water softener

2. Loading the salt into the softener

3. Loading the basket
4. Fill the dispenser
Please check the section 1 "Water Softener" of
PART II: Special Version, if you need to set
the water softener.
Loading the Salt Into The Softener
NOTE:
If your model does not have any water softener,
you may skip this section. Always use salt
intended for dishwasher use.
The salt container is located beneath the lower
basket and should be filled as explained in the
following:
WARNING
• Only use salt specifically designed for
dishwashers use!
Every other type of salt not specifically
designed for dishwasher use, especially table
GB-10
salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the
manufacturer does not give any warranty nor is
liable for any damages caused.
• Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water,
which may have been spilled, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
Please follow the steps below for adding
dishwasher salt:
1. Remove the lower basket and unscrew the
reservoir cap.
2. Place the end of the funnel (supplied)
into the hole and pour in about 1.5kg of
dishwasher salt.
3. Fill the salt container to its maximum limit
with water, It is normal for a small amount of
water to come out of the salt container.
4. After filling the container, screw back the cap
tightly.
5. The salt warning light will stop being after
ENGLISH
GB-11