Electrical Requirements; Water Connection - FAR LV12C47MI18W Manuel D'utilisation

ENGLISH

Electrical Requirements

Please look at the rating label to know the
rating voltage and connect the dishwasher to
the appropriate power supply. Use the required
fuse 10 amp, time delay fuse or circuit breaker
recommended and provide separate circuit
serving only this appliance.
Electrical Connection
Ensure the voltage and
frequency of the power
being corresponds to
those on the rating
plate. Only insert the plug into an electrical
socket which is earthed properly. If the electrical
socket to which the appliance must be connected
is not appropriate for the plug, replace the socket,
rather than using a adaptors or the like as they
could cause overheating and burns.

Water Connection

Cold Water Connection
Connect the cold water supply hose
to a threaded 3/4(inch) connector
and make sure that it is fastened
tightly in place.
If the water pipes are new or have not been
GB-46
Insure proper
ground exists before
use
used for an extended period of time, let the
water run to make sure that the water is clear.
This precaution is needed to avoid the risk of
the water inlet to be blocked and damage the
appliance.
WARNING! Please close the hydrant after
using.
Drain hose Connection
Insert the drain hose into a drain pipe with
a minimum diameter of 40mm, or let it run
into the sink, making sure to avoid bending or
crimping it. The top of the hose must be less
than 1000mm.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B
Front
NOTE
The top of the
hose must be less
than 1000mm.
Drain pipe
ENGLISH
Counter
GB-47