Water Softener; Loading The Salt Into The Softener - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH
NOTE:
If your model does not have any water softener,
you may skip this section.

WATER SOFTENER

The hardness of the water varies from place to
place. If hard water is used in the dishwasher,
deposits will form on the dishes and utensils.
The appliance is equipped with a special softener
that uses a salt container specifically designed to
eliminate lime and minerals from the water.
B. Loading the salt into the softener
Always use the salt intended for dish washer use.
The salt container is located be neath the lower
basket and should be filled as explained
in the following:
Warning!
• Only use salt specifically designed for
dishwashers use! Every other type of salt
not specifically designed for dishwasher use,
especially table salt, will damage the water
softener. Incase of damages caused by the use
GB-20
of unsuitable salt the manu facturer does not
give any warranty nor is liable for any damages
caused.
• Only fill with salt before running a cycle. This
will prevent any grains of salt or salty water,
which may have been spilled, remaining on
the bottom of the machine for any period of
time, which may cause corrosion.
open
A. After the lower basket has been removed,
unscrew and remove the cap from the salt
container. 1
B. Place the end of the funnel (supplied)
into the hole and poor in about 1. 5kg of
dishwasher salt .
C. Fill the salt container to its maximum limit
with water. It is normal for a small amount of
water to come out of the salt container. 2
ENGLISH
GB-21