American Standard VorMax Plus Instructions D'installation Et D'entretien page 2

CAUTION
:
!
IF A VORMAX PLUS FRESHINFUSER IS NOT SECURELY INSERTED INTO THE SPUD OPENING,
NOT FLUSH THE TOILET
VORMAX PLUS FRESHINFUSER INSERTED IN THE SPUD OPENING AT ALL TIMES WHEN FLUSHING THE TOILET.
For further assistance please call Customer Care at: (800) 442-1902
1
Assembly of Housing Base Plate
Read carefully then remove CAUTION sticker (1)
next to spud (2) from rear of bowl.
Insert rubber grommets
(3) (narrow end rst) up
underneath the bowl
and into each seat
mounting hole. Ensure
grommets stay in place
in bowl.
4
Seat Alignment
Place seat onto the protruding Base Plate Posts
and press in to "click" into place, close seat and
cover and align seat with bowl. Once aligned,
further tighten seat nuts under bowl to securely
hold seat in position.
Remove seat by pressing both inside buttons
to release seat and cover:
Open the seat and cover. Push both inside
buttons to release seat and cover. Pull the seat
and cover upwards to take it off the hinges.
7302351-100 Rev. A 8/17
AS THIS MAY RESULT IN WATER LEAKING FROM THE TOILET. TOILET MUST HAVE A
1
2
3
Check that rubber gasket is rmly
attached to the underside of the base
plate (1) and place plate over Spud (2)
and rear of bowl while aligning the two
mounting holes through the bowl.
Install VorMax Plus Housing (1) onto
VorMax Plus Base Plate (2), snap in
to secure.
2
1
2
5
1
2
2
3
From above, install mounting screws and
washers (1) through each hole, then place
rubber washer (2) and plastic nut (3) from
underneath onto each bolt. Snug down but
do not fully tighten.
6
Open Base Plate Housing Door (1). Observe the
marked notch on the VorMax Plus FreshInfuser
(2). Observe the same marked notch located on
the Base Plate Housing.
Before installing, line up the marked notches on
the Base Plate Housing and the VorMax Plus
FreshInfuser.
Insert the VorMax Plus FreshInfuser into the spud
opening aligning the marked notch on the VorMax
Plus FreshInfuser and the Base Plate Housing.
Marked Notch
on VorMax Plus
FreshInfuser
2
Marked Notch
on VorMax Plus
FreshInfuser
2
UNLOCKED
DO
Notch on Base
Plate Housing
Door
Notch on Base
Plate Housing
Door
1