Finishing; Anti Condensation Switch; Control Cover Installation - Napoleon Ascent Série Manuel D'installation

WARNING
!
• Risk of fire!
• Never obstruct the front opening of the appliance.
• The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specified dimension, as illustrated.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or finishing material must never overhang into the appliance opening.
• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.

11.1 anti condensation switch

This appliance has the option to change from an electronic intermittent pilot ignition (IPI) to a standing pilot for cold
climates. The anti condensation control (standing pilot) is located to the left of the control panel. Using your finger,
flip the switch up for standing pilot or down for intermittent pilot ignition.
Turning the ACS switch on will allow the pilot flame to burn continuously. This mode will minimize the
condensation which forms on the inside of the glass when the main burner is first turned on. It will also help the
appliance and vent system stabillize more quickly during the colder months.
During the warmer winter and summer months, the ACS switch can be turned off to minimize fuel consumption.

11.2 control cover installation

Slide the back edge of the control cover down between the glass and the door frame. Insert downwards.

11.0 finishing

finishing
41
W415-1705 / 06.07.17
EN