Cleaning And Maintenance - Krups XP2280 Mode D'emploi

KR_XP2280_NAFTA_NC00026071-01 17/11/11 17:55 Page9
English
n The Espresso
LED and the pictogram
flash after a few moments.
n For best results, hold the nozzle towards the bottom of the container for about 25 seconds while the
milk heats up (without however touching the bottom of the container). Then, bring the container down
gradually so that the nozzle moves up towards the surface (without the nozzle coming out of the milk)
(Fig. 14).
n Once the froth has been formed, turn the knob to "0" position (Fig. 15). The appliance will now
automatically cool down by launching intermittent pumping cycles. Once this automatic operation is
complete, you can make a coffee.
IMPORTANT : To prevent the steam nozzle from being clogged, the milk foam must
never reach the black plastic upper part.
It is important to clean the steam nozzle after each use to prevent the milk from drying on the inside of the
nozzle. To do this:
n Place the steam nozzle in a container with water and repeat the milk frothing operation for 30 seconds.
WARNING!
The steam nozzle will be hot!
USING THE AUTO-CAPPUCCINO ACCESSORY TO FROTH MILK
The auto-cappuccino accessory makes it easy to prepare a cappuccino or a caffe latte. It comprises a
special dual-position nozzle and a pipe.
n Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4).
n Attach the auto-cappuccino accessory firmly to the articulated arm.
n Place a cup under the auto-cappuccino accessory.
n Pour about 100 ml of cold semi-skimmed milk into a container.
n Immerse the pipe into the container, or directly into the carton of milk.
Warning:
Assemble the pipe firmly on the cappuccino accessory (fig.24).
n Turn the accessory's switch to "cappuccino" or "latte" position.
n Press the "steam preheating" button (Fig. 12). During the pre-heating, the
pictogram flash.
n As soon as the appliance reaches the right temperature, the
steadily. Turn the knob to
n Once the froth has been formed, turn the knob to "0" position (Fig. 15). The appliance will now
automatically cool down by launching intermittent pumping cycles. Once this automatic operation is
complete, you can make a coffee.
n To clean the auto-cappuccino accessory, please repeat the procedure for frothing milk, but this time with
100 ml of water instead of 100 ml of milk.
n For more thorough cleaning of the auto cappuccino accessory, please refer to the section "Cleaning and
Maintenance".

4 . CLEANING AND MAINTENANCE

Do not wash your espresso machine accessories in the dishwasher.
9
remain steady when the steam begins to be produced and can
position (Fig. 13). The milk is transferred from the container to the cup.
Espresso
LED and the
Espresso
LED and the pictogram glow