Tips; Before First Use - Krups XP2280 Mode D'emploi

KR_XP2280_NAFTA_NC00026071-01 17/11/11 17:55 Page5
English
ESPRESSO

TIPS

n For an intensely aromatic espresso, we recommend that you use freshly ground special espresso
coffee which is ideal for preparing this type of delicate beverage, as well as cups with a capacity not
exceeding 50 ml.
n Keep the ground coffee in the refrigerator to preserve its aroma longer.
n Do not fill your filter holder to the brim, but use the measuring spoon (1 cup = 1 spoon –2 cups =
2 spoons) (Fig. 5).
n If you do not use the appliance for more than 5 days, rinse and drain the water tank.
n Always remember to turn off the appliance before removing the tank to fill or empty it.
n Make sure you always place the appliance on a flat stable surface.
n To obtain an espresso at exactly the right temperature, we recommend that you preheat your cups.
n To prolong the service life of your appliance, we recommend that you always use a Claris Aqua Filter
System cartridge (reference: F088) and that you descale the appliance at regular intervals.
IMPORTANT!
Before using for the first use, after a prolonged period of inactivity or after descaling,
the appliance must be cleaned as described in paragraph 1: "BEFORE FIRST USE".

1. BEFORE FIRST USE

Before using your espresso machine, clean all the accessories in soapy water and dry them.
A. SETTING THE TIME (to be done on first use and after a power cut)
n Your XP2280 combo machine has a display making it easy to use and providing a wide range of
settings.
n You must set the clock when you plug in your appliance for the first time or after a power cut.
n You can set the clock in European (24-hour clock) or American (AM-PM) display mode.
n To do this, simultaneously press the "H" and "m" buttons below the display.
n Then set the hours by pressing the "H" button and the minutes by pressing the "m" button.
Make sure the steam knob on the left of the appliance is in 0 position.
If you are not using the Claris cartridge, go directly to paragraph "C. RINSING YOUR
APPLIANCE".
B. INSTALLING THE CLARIS CARTRIDGE (to be done every time the cartridge is replaced)
n Screw the Claris cartridge into the bottom of the tank.
n Fill the tank with water (Fig. 2).
n Replace the tank by positioning it firmly to ensure that water can enter and then close the lid (Fig. 3).
n Place a container under the steam nozzle.
n Turn on the appliance by pressing the
n As soon as the appliance reaches the right temperature, the
pictograms and
n Turn the knob on the side of the appliance to
n At the start, steam will come out through the steam nozzle and the four pictograms in the display and
Espresso
the LED will begin to flash.
n Turn the knob to "0" position (fig.15).
n Turn off the machine and then turn it on again by pressing the
n Return to knob to
nozzle, repeat the operation from the start 1 or 2 times.
5
Espresso
button (fig.4).
are displayed.
: position: water flows out of the steam nozzle. If water does not flow from the
Espresso
LED glows steadily and the
(fig.13).
Espresso
button twice.