Agri-Fab 45-0456 Mode D'emploi page 9

DUMP
LEVER
DRAWBAR
OFFSET
TUBE
DRAWBAR
HEIGHT ADJUSTMENT HOLES
Hopper Bag
Dump lever
windscreen
Bag arm Channels
Pivot rod
Height adjustment Handle
Height adjustment Holes
Knob
Drawbar
Drawbar offset Tube
How To use Your sweePer
BrusH HeIGHT aDJusTmenT
To adjust sweeper brushes to best operating height,
loosen adjustment knob and push down on height
adjustment lever to raise the brush, or push up on
the lever to lower the brush. See figure above. Best
adjustment is when the brush setting is 1/2" down into
the grass. Always mow the grass to an even height
before sweeping.
sweePInG sPeeD
Try a starting speed of approximately 3 m.p.h. (third gear
on most tractors). Depending on the conditions, it may
be necessary to adjust the sweeping speed in order to
achieve best results.
oPeraTIon
WINDSCREEN
PIVOT ROD
KNOB
HEIGHT ADJUSTMENT HANDLE
Collects grass clippings, leaves and debris.
Permits dumping of hopper bag from driver's seat.
Helps prevent collected material from being blown out of hopper bag.
Connects the hopper bag to the sweeper housing.
Allows hopper bag to tilt forward to dump material.
Adjusts the operating height of the sweeper.
Holds the height adjustment handle in position when locked.
Locks the height adjustment handle into a height adjustment hole.
Connects the sweeper to the towing vehicle. Adjusts for various height tractor hitches.
Allows drawbar to be offset from tractor.
BAG ARM
CHANNELS
DumPInG oF sweePer
Your sweeper can be dumped without getting off of the
rider or tractor. Pull the dump lever forward to empty the
hopper. Always empty hopper after each use.
DrawBar oFFseT
The drawbar can be attached to the center, left hand or
right hand set of holes in the drawbar offset tube.
CauTIon: Keep sweeper away from fire.
Excessive heat can damage the brushes and
hopper bag and could cause the bag and its
contents to burn.
9
HOPPER
BAG