Operation - Omcan MS-IT-0220-C Manuel D'instructions

on the machine plate.
COMMANDS
START AND STOP BUTTONS / SWITCHES
• Turn switch or press the white or green button (1) to start running the blade.
• The light turns on to indicate that the machine works correctly.
• Turn switch or press the red or black button to stop the blade.
Slice thickness can be adjusted by turning the graduated knob (4) counterclockwise.
Thickness adjustment range: see paragraph "Technical description and conditions of use".
FUNCTIONING TEST AND BLADE ROTATION DIRECTION
Start the machine and check whether the light is on; make sure that the blade rotates in the direction indicated
by the arrow (counterclockwise if you look at the machine from the blade plate side).
• Ascertain that the carriage and the product grip slide correctly.
• Ascertain that the gauge plate works and adjust thickness to desired value.
USING THE MACHINE
LOADING THE PRODUCT ON THE TRAY AND SLICING
• Ascertain that the thickness control knob is correctly positioned to '0'.
• Draw back the carriage completely (towards the operator) to loading position.
• Lift the product grip by pulling it away by 10 cm from the blade and put it in rest position.
• Lay the product to be sliced against the guide plate on the operator side.
9
Installation

Operation