Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GENERAL SAFETY REGULATIONS
The slicers must be used only by suitably trained personnel. Furthermore, this personnel must have read this
manual carefully. In particular, please comply to the following instructions:
•
Install the machine according to the instructions contained in the "Installation" section.
•
Do not modify nor exclude the mechanical and electrical safety devices.
•
Do not use the machine with improvised connections, or provisional or non insulated cables.
•
Check the power cable and gland plate on the machine body regularly and when necessary have them
replaced by qualified personnel.
•
In case of anomalies, defective operation, incorrect movement, unusual noise, etc stop the machine
immediately.
•
Before cleaning or servicing, disconnect the machine from the mains.
•
Always use scratch-proof and non-slip gloves during cleaning or maintenance.
•
Lay or remove the goods to be sliced on the sliding plate only when the latter is completely pushed back
and the thickness control knob positioned to 0.
•
To move the carriage tray when slicing, use the handle or the product grip handle.
•
For extraordinary maintenance (to replace the sharpener wheels, the blade, or others) please contact the
manufacturer or qualified and duly authorized personnel.
•
Avoid running the slicers with no product on it.
•
The slicers are equipped with a ventilated motor. Extended continual use is not recommended. Let the
motor cool down after 30 minutes of use.
MANUFACTURER'S WARRANTY AND LIABILITY
The manufacturer's warranty covering the good functioning of the machines and their compliance to the
service for which they have been designed depends on the correct application of the instructions contained in
this manual. The Manufacturer assumes no liability either direct or indirect deriving from:
•
Failure to comply with the instructions contained in this manual.
•
Use of the machine by personnel who has not read or fully understood the content of this manual.
•
Use not complying to the specific norms currently applicable in the country of installation.
•
Unauthorized modifications and/or repairs.
•
Use of non original accessories or spare parts.
•
Exceptional events.
ENVIRONMENTAL CONDITIONS OF USE
Temperature: from -5°C and 40°C / 23°F and 104°F.
Relative humidity: max 95%.
OPENING THE BOX
On reception check packaging integrity, otherwise inform the forwarding agent or the area agent immediately.
To unpack the machine, proceed as follows:
•
Open the box and remove your copy of the manual of use and maintenance, then proceed according to the
Safety and Warranty
5
Publicité
Table des Matières
Dépannage
