Troubleshooting; Dismantling The Slicer - Omcan MS-IT-0220-C Manuel D'instructions

Troubleshooting

The table below indicates the most common problems that may arise during slicing and the necessary
remedies.
PROBLEM
The machine does not start
when the white or green button is
pressed.
When the switch is turned or
when the white or green button is
pressed, the machine starts, but
the white functioning light is not on.
The machine starts, but there are
vibrations. The motor is very hot
and there is a bad smell.
Under strain, the machine slows
down or comes to a stop.
Excessive resistance to product
slicing.
The slices are ragged and/or
shaped irregularly.
Unsatisfactory blade sharpening.
The product tray does not slide.
When the switch is turned or when
the black or red button is pressed,
the machine does not stop.

DISMANTLING THE SLICER

These machines are made of the following elements:
• Aluminium frame.
• Stainless steel fittings and others.
• Electrical parts and cords.
• Electrical motor.
• Plastic materials, etc.
Whether dismantling is entrusted to third parties or done in-house (in that last case you will have to separate
the various materials) please note that disposal of the materials can only be carried out by duly authorized
businesses. In any case, please comply to the current norms of your country.
POSSIBLE CAUSE
No power supply.
The blade guard is not correctly
positioned.
Defective electrical control circuit.
Defective indicator.
Defective motor or transmission.
Defective transmission.
The blade is blunt.
The blade is blunt.
The blade is excessively worn out.
Worn wheels.
Guides are insufficiently lubricated. Lubricate.
Defective electrical control circuit.
14
REMEDY
Ascertain that the plug is correctly
inserted.
Check.
Call technical assistance.
Do not use the machine when the
pilot lamp is not on; Call technical
assistance.
Do no use the machine, call
technical assistance.
Call technical assistance.
Sharpen the blade.
Sharpen the blade.
Call technical assistance.
Replace the wheels; call technical
assistance.
Stop the machine, unplug
from mains and call technical
assistance.