Waldmann IDOO.line Mode D'emploi page 41

Mounting the modular system
X Turn the luminaire such that bottom side
points upwards.
Removing the cover
Fig. 18: Removing the cover.
NOTE: This step is required only when
mounting a middle luminaire. In the case
of an end luminaire, the cover can remain
mounted.
X Remove the cover B on the side of
direct light emission, see Fig. 18.
Taking out the reflector
Fig. 19: Disengaging the reflector.
B
C
NOTE: This step is required only when
mounting a middle luminaire. In the case of
an end luminaire, the reflector can remain
mounted.
X Push one side wall of the luminaire out-
ward by pushing the reflector C in the
opposite direction at the same time,
see Fig. 19.
Fig. 20: Taking out the reflector.
X Remove the reflector C from the lumi-
naire and place it beside the luminaire,
see Fig. 20.
Mounting the wire rope holder
Fig. 21: Mounting the wire rope holder.
X Guide the wire rope D through the guide
bushing E of the wire rope holder F,
see Fig. 21.
X Push the guide bushing downwards
and adjust the wire rope to the desired
length.
ENG
C
D
E
F
41