Preparing For Cold Lamination - UNITED OFFICE ULG 350 B1 Mode D'emploi

Preparing for cold lamination

IMPORTANT
► After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination . Bear in mind, the rollers inside the laminator
will still be hot . This could damage the laminating pouch and the document
to be laminated!
♦ Insert the plug of the laminator into a mains power socket .
♦ Switch the appliance on by pushing the On/Off switch
The red Power indicator light
♦ Set the selector switch for hot and cold lamination
Ready indicator light
♦ Place the pouch thickness switch
(see also chapter Switching levels) .
♦ Place the document to be laminated into a laminating pouch of the appropriate
size .
NOTICE
► Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig . 1 .
► Make certain that you use only one pouch for laminating . First flip it up, as
shown in Fig . 2 .
► For further information about the lamination process, please read the section
Lamination process .
■ 8 │ GB │ IE
lights up .
2
lights up .
3
at the corresponding pouch thickness
4
to the "ON" position .
5
to "COLD" . The green
6
ULG 350 B1