Removing And Replacing The Oven Door - IKEA LAGAN Mode D'emploi

EN

removing and replacing the Oven Door

CAUTION
The door is heavy. For safe, temporary storage, lay
the door flat with the inside of the door facing down.
To remove the oven door:
1. Open oven door completely, horizontal with floor.
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame com-
pletely towards the oven door (See Figure 18).
A tool such as a small flat-blade screwdriver
may be required.
3. Firmly grasp both sides of oven door along the
door sides. Do not use the oven door handle
(Figure 19)
4. Close the door to approximately 10 degrees
from the door frame (Figure 19).
5. Lift the oven door hinge arms over the roller
pins located on each side of the oven frame
(Figure 20)
To replace Oven Door:
1. Firmly grasp both sides of oven door along the
door sides. Do not use the oven door handle
(Figure 19).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm
over the roller pins located on each side of the
oven door frame (See Figure 20). The hook of
the hinge arms must be fully seated onto the
roller pins.
3. Fully open the oven door, horizontal with floor
(Figure Figure 17).
4. Push the door hinge locks up towards and into
the oven frame on both left and right oven door
hinges to the locked position (Figure 18).
5. Close the oven door.
IMpOrTANT
Special door care instructions - Most oven doors
contain glass that can break. Do not hit the glass
with pots, pans, or any other object. Scratching,
hitting, jarring, or stressing the glass may weaken
its structure, causing an increased risk of breakage
at a later time. Do not close the oven door until all
of the oven racks are fully in place.
CArE AND CLEANING
Figure 17: Door hinge location
Figure 18: Door hinge Locks
oven
door
Figure 19: Holding door for removal
roller
pin
hinge
arm
Figure 20: replacement and location of hinge
arm and roller pin
Oven door
hinge
locations
about
10°
hinge
25