IKEA LAGAN Mode D'emploi page 24

CArE AND CLEANING
Cleaning the sealed burners
To avoid possible burns, do not attempt cleaning
before turning off all surface burners and allowing
them to cool.
Any additions, changes, or conversions required in
order for this appliance to satisfactorily meet the
application needs must be made by an authorized
qualified Agency. Routinely clean the cooktop. Wipe
with a clean, damp cloth and wipe dry to avoid
scratches. Keeping the surface burner head ports
and slots clean will prevent improper ignition and
an uneven flame.
To clean recessed and contoured areas of cooktop:
• If a spill occurs on or in the recessed or con-
toured areas, blot up spill with an absorbent
cloth.
• Rinse with a clean, damp cloth and wipe dry.
CAUTION
• To avoid possible burns do not attempt to op-
erate the surface burners without the burner
caps.
• Do not use spray oven cleaner on the cooktop.
To clean burner heads:
1. Remove the burner cap from the burner head
(see Figure 15). Clean the cap with hot soapy
water and dry thoroughly.
Burner Cap
Burner Head
Figure 15: Burner Cap
2. For burned-on and dried spills, apply hot soapy
water to the burner head. Allow time for the
soils to soften.
3. Use a toothbrush to clean all over the burner
head (see Figure 16).
4. Use the toothbrush to clean the slots and holes
in the burner (see Figure 16).
5. Use a needle or fine wire to clean out the igni-
Correct Burner Cap
tion port (see Figure 16).
Placement
6. Wipe the burner head clean with a soft, clean
cloth, sponge, or scratch-free cleaning pad.
24
Burner Cap Lip
Incorrect Burner Cap
Placement
7. Before using the cooktop again, make sure the
burner caps are properly placed and seated on
the burner heads. When placed correctly, the
burner cap is centered on the burner head and
will click into place on the burner head. You
can wiggle the cap to test placement, it should
not move off the burner head "Assembly of the
Burner Caps" on page 12.
slots
ignition port
ignitor
Figure 16: Cooktop cleaning
Important notes:
• The surface burner heads are secured to the
cooktop and must be cleaned in place on the
cooktop.
• Always keep the surface burner caps in place
whenever a surface burner is in use.
• When replacing the burner caps, be sure the
burner caps are seated firmly on top of the
burner heads.
• For proper flow of gas and ignition of burners
do not allow spills, food, cleaning agents, or
any other material to enter the gas orifice port
opening.
EN
orifice port