Specification Chart; Basic Air Compressor Components - Porter Cable PXCMLA4708065 Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

vibration pads (094-0137) under tank feet.

5. Fasten the compressor down securely if transporting is necessary. Pressure

must be released from the tank before transporting.

6. Protect the air hose from damage and puncture. Inspect them weekly for

weak or worn spots, and replace if necessary.

7. To reduce the risk of electric shock, do not expose to rain. Store indoors.

CALIFORNIA PROPOSITION 65 WARNING: This product contains chemicals

known to the State of California to cause cancer, birth defects and/or

reproductive harm.

MODEL NO.

PXCMLA4708065

BASIC AIR COMPRESSOR COMPONENTS

The basic components of the air compressor are the electric motor, Thermal

Overload Protection System (TOPS), pump, and receiver (tank).

The electric motor (see A) powers the pump.

TOPS senses both temperature and current, providing more complete motor

overload protection than a magnetic starter, which senses only current. If TOPS

senses an overload condition, it will automatically shutdown the compressor.

Allow 10-15 minutes for the unit to cool down, then press the reset button on

the motor to restart the compressor.

The pump (see B) compresses the air and discharges it into the tank.

The tank (see C) stores the

compressed air.

The pressure switch (see

D) shuts down the motor

and relieves air pressure in

the pump and transfer tube

when the air pressure in the

tank reaches the kick–out

pressure. As compressed

air is used and the pressure

level in the tank drops to

the kick–in pressure, the

pressure switch restarts the

motor automatically, without

warning and the pump

resumes compressing air.

The air line outlet (see E).

Connect 1/4" NPT air hose to

this outlet.

WARNING