Table des Matières
Publicité
IT
EN
pag. 4
page 21
ES
PT
pág. 91
pág. 108
HU
CS
old. 164
str. 182
NO
SV
sid. 233
sid. 250
MultiGrill
www.delonghi.com
ELECTRICAL CONNECTION
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be
cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug
after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on
type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event
of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructions provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow:
Blue:
Brown:
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or
the earth symbol
or coloured green or green and yellow. The blue wire must be connected to the terminal marked with
the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red.
FR
DE
page 38
S.55
EL
RU
σελ. 125
стр. 144
SK
PL
str. 199
str. 216
DA
FI
sid. 267
siv. 284
Earth
Neutral
Live
NL
pag. 74
KZ
Бет. 301
2
Publicité
Table des Matières
