Snap Disc Replacement; Igniter Replacement; Baffle Removal & Replacement - Pleasant Hearth PH35PS Serie Manuel Du Propriétaire

5
Replacement Parts
C

. Snap Disc Replacement

Power - Manual Reset
1. Turn the dial control to the off position. Unplug the power
to the unit.
2. Using #2 Phillips screwdriver, loosen the bolts on the rear
of the unit holding on the left side panel. You do not need
to remove the screws. Remove side panels by lifting up
and out.
3. Locate the snap disk on the top side of the feed tube
where it meets the hopper. Disconnect the wire leads
from the snap disk.
4. Using a #1 Phillips screwdriver, remove two 6-32 fasten-
ers retaining the snap disk onto the side of the feed tube.
5. Using the same fasteners, attach the new snap disk.
Attach the wire leads.
6. Restore power.
20
D. Igniter Replacement
1. Turn the dial control to the off position. Unplug the
power to the unit.
2. Unplug the wire leads to the igniter.
3. Remove the screw in the side of the igniter chamber.
Pinch the ends of the bracket together and pull the
igniter straight out of the igniter chamber.
4. If there is difficulty in removing the igniter from the
chamber, the chamber can be removed from the rear
of the firebox by removing the the 1/4-20 bolt.
5. Re-install the new igniter into the chamber using the
bracket.
6. Inspect the igniter from the front of the unit by removing
the firepot and looking into the end of the chamber.
MAKE SURE THE IGNITER IS CENTERED IN THE
CHAMBER.
E. Baffle Removal & Replacement
1. Turn the dial control to the off position. Make sure the
unit is cool.
2. Remove the center baffle first by using the handle at
the top of the baffle and pull up and then towards you.
The hooks on the baffle will slide out of the slots in the
bracket.
3. Remove the left baffle and then the right baffle by pulling
up and then towards you. The left and right baffles have
similar hooks and slots.
7077-171I • December 08, 2016 (877) 447- 4768