Disposal Of Ashes - Pleasant Hearth PH35PS Serie Manuel Du Propriétaire

4
Maintaining & Servicing Your Appliance
2. Cleaning Firepot with the Firepot Clean-Out Tool;
• Frequency: Daily or more often as needed
• By: Homeowner
a. The appliance must be in complete shutdown and cool
and the exhaust blower off. If you are just cleaning the
firepot, there is no need to unplug the appliance.
b. Open the front door of the appliance and lift out the
firepot. Use the firepot cleaning tool to break up
deposits inside the firepot and dispose in an approved
container. Depending on the quality of fuel used, the
front of the firepot may need to be removed for better
access for cleaning.
c. Use the narrow end of the firepot cleaning tool to clean
the holes.
d. With the firepot out clean the area below the firepot.
e. Reassemble the firepot and place back inside the firepot
riser. Make sure the firepot is in the correct direction
with the slanted lip in the rear. Failure to install the
firepot correctly may result in missed ignitions.
14
3. Ash Removal from Firebox
• Frequency: Weekly or more frequently depending on
• By: Homeowner
a. There must not be any hot ashes in the firebox during
cleaning so allow the appliance to completely cool. The
firebox ash should be removed every time the exhaust
path is cleaned. Frequent cleaning of the ash in the
firebox will help slow down the build-up of ash in the
exhaust blower and vent system.
b. V acuum out the firebox thoroughly on both sides of the
firebox and the floor and ceiling. Remember to place
the ash and debris into a metal or non-combustible
container.
See Disposal of Ashes.

4. Disposal of Ashes

• Frequency: As needed
• By: Homeowner
Ashes should be placed in a metal container with a
tight-fitting lid. The closed container of ashes should
be placed on a non-combustible floor or on the ground,
well away from all combustible materials, pending final
disposal.
If the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the
closed container until all cinders have been thoroughly
cooled.
7077-171I • December 08, 2016
Front of
MAXIMUM
PELLET LEVEL
has the
lip
Back
Hole for Igniter
ash build-up.
WARNING
Disposal of Ashes
• Ashes should be placed in metal container
with tight fitting lid.
• Ashes should be retained in closed container
until all cinders have thoroughly cooled.
(877) 447- 4768