Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
Maintaining & Servicing Your Appliance
6. Cleaning the Glass
•
Frequency: When clear view of the firepot becomes
obscure
•
By: Homeowner
a. Appliance must be completely cool before cleaning
glass.
b. Vacuum fly ash from glass and door rope.
c. Use a damp paper towel or any non-abrasive glass
cleaner. Wipe off with dry towel.
CAUTION
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
30
[762]
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Refer to maintenance instructions.
• Do NOT operate with glass cracked,
broken or scratched.
7. Cleaning the Hopper
•
Frequency: Monthly or after burning 25 bags of fuel
•
By: Homeowner
After burning approximately 25 bags of fuel you will
need to clean the hopper to prevent sawdust build-up.
A combination of sawdust and pellets on the bottom
end of the auger reduces the amount of fuel supply to
the firepot. This can result in nuisance shutdowns and
mis-starts.
a. The appliance must be in complete shutdown.
Allow the appliance to completely run out of pellets
and cool down.
b. Empty the hopper of any remaining pellets.
c. Vacuum the hopper and feed tube. To access the
feed tube remove the four screws from the auger
cover located inside of the hopper.
customerservice@ghpgroupinc.com
slamming glass.
8. Cleaning the Exhaust Path, Baffles & Drop Tube
•
Frequency: Monthly or every 25 bags or more fre-
•
By: Homeowner
a. Appliance must be completely cool.
b. Open the door and remove the center baffle first and
then the right and left baffles. Thoroughly vacuum the
exhaust path and drop tube and continue throughout
the rest of the firebox. Also vacuum the front and
back of the baffles.
c. Using a small brush, clean the inner walls of the
exhaust outlet from the access hole inside the firebox.
The access hole will be visible following the removal
of the left side baffle. After loosening up debris on
the inner walls of the outlet, vacuum out.
This is important as the exhaust temperature
probe is attached to the right side of the outlet.
If this is not maintained on a regular basis, the
appliance will experience nuisance shut downs
and/or missed ignitions.
d. Replace the right and left baffles and then the center
baffle and close and latch the door.
9. Door Handle Inspection
•
Frequency: Monthly or prior to heating season
•
By: Homeowner
The gasketing between the glass and firebox should be
inspected periodically to make sure there is a good seal.
NOTE: GHP recommends using a heavy duty vacuum
cleaner specifically designed for solid fuel appli-
ance cleaning.
7077-171I • December 08, 2016
quently depending on ash build-up.
2
3
1
15
Publicité
Chapitres
Table des Matières
