Bucking A Log - Remington EL-7 16 Manuel Du Propriétaire

OPERATING CHAIN
SAW
Continued
LIMBING A TREE
WARNING: Avoid kickback.
Kickback can result in severe in-
jury or death. See Kickback, page
3, to avoid risk of kickback.
WARNING: When cutting limb
that is under tension, use extreme
caution. Be alert for wood spring-
ing back. When wood tension is
released, limb could spring back
and strike operator causing se-
vere injury or death.
CAUTION: Seek professional
help if facing conditions beyond
your ability.
Limbing is removing branches from a fallen
tree. Make sure your footing is firm. Keep
feet apart. Divide your weight evenly on
both feet. Do not remove larger limbs un-
der tree that support log off ground. Remove
each limb with one cut (see Figure 13). Clear
cut limbs from work area often. This will
help maintain a safe work area.
Make sure you start your cut where limb
will not pinch saw during cutting. To avoid
pinching, start cut on freely hanging limbs
from above limb. Start cut on limbs under
tension from under limb. If pinch occurs,
turn saw off, lift limb, and remove saw.
Figure 13 - Limbing A Tree
105020
For parts contact: www.PartsFor.com

BUCKING A LOG

WARNING: Avoid kickback.
Kickback can result in severe in-
jury or death. See Kickback, page
3, to avoid risk of kickback.
WARNING:
• If on slope, make sure log will
not roll down hill. Secure log
by using wooden stakes. Drive
wooden stakes into ground on
downhill side of log. Stand on
uphill side of log while cutting.
Log may roll after cutting.
• Never try cutting through two
logs at same time. This could
increase the risk of kickback.
• While cutting log, never hold
log with your hand, leg, or foot.
• While cutting log, never allow
another person to hold log.
• Turn off and unplug saw be-
fore moving from one place to
another.
CAUTION: Seek professional
help if facing conditions beyond
your ability.
11
OWNER'S MANUAL
Bucking a log is cutting a log into sections.
Make sure your footing is firm. Keep feet
apart. Divide your weight evenly on both feet.
Stand slightly to left of saw. This keeps your
body from being in direct line with chain.
When possible, raise log or section off ground.
Do this by using limbs, logs, chocks, etc.
When cutting through log, maintain control
by reducing cutting pressure near end of cut.
Do not relax your grip on chain saw handles.
Do not let moving chain touch ground.
Ground will dull moving chain. After cut-
ting through log, release trigger to turn saw
off before moving saw.
Follow directions below to buck a log.
Entire Length Of Log On
Ground
Cut log from top (see Figure 14).
Figure 14 - Bucking Log With Entire
Length On Ground
For more information, visit www.desatech.com
Continued