Sound Control - Panasonic CQ-C5405U Manuel D'instructions

General
 Up
 Down
Setting Range: 0 to 40
Default: 18
Volume Off (down)
Press [MUTE].
Cancel
Press [MUTE] again.
Note: You can select mute or attenuation. (
The source changes as follows every time [SOURCE]
is pressed.
AUX1 (AUX1 in) (3.5 mm  stereo)
From line output of external sound/audio device (ex.
Silicon-audio player, HDD player, etc.)
Radio

FM1, FM2, FM3, AM ( page 14)
Player

When loading CD ( page 16)

When loading MP3/WMA/AAC disc (
AUX1
Device connected to the AUX1 terminal of this unit
12
CQ-C5405U/C5305U
Note: The volume level can be set independently for
each source. (For radio, one volume setting for AM, one
volume setting for all FMs)
Caution
• Set the volume level to low enough before the

page 23) AUX connection is completed.
Failure to observe this, the loud noise may come
out and damage your speakers and your hearing.
System-up Connector
When an optional device is connected:
Shift to connected device
When connecting CD changer
When connecting iPod
When connecting XM Receiver
page 18)
When connecting Sirius Receiver
OR
When an expansion module is connected:
The devices connected to the ports 1 to 4 are
activated in sequence after shifting to AUX2 (device
connected to the AUX terminal of the expansion
module).
Note: For information about connectable devices, refer
to the System Upgrade Guidebook or the instruction
manual for each device.

Sound Control

You have 6 preset modes (FLAT, ROCK, POP, VOCAL,
JAZZ, CLUB). You can customize your settings for these
and save them for instant recall.
SQ Changeover
 Press [SQ] to activate the SQ selection mode.
 Press [SQ] to select the sound type as follows.
Press [DISP] to return to the regular mode.
Notes:
• After pressing [SQ] on the main unit, you can also
select a sound type by pressing the preset buttons [1]
to [6].
• Please refer to page 22 for the adjustment to each
speaker and an optional subwoofer.
· Bass adjustment
· Treble adjustment
· Balance adjustment
· Fader adjustment
· Subwoofer level adjustment
· Subwoofer low pass fi lter
· Re-master setting
You can adjust the characteristics of the currently

selected sound type (SQ). ( above)
It is also possible to preset up to 5 different adjusted
SQs.
SQ3 (3-Band Sound Quality)
Center frequency and level are adjustable in each of
3 bands. This lets you fi ne-tune sound quality for each
genre to suit car-interior acoustics and your personal
preferences.
Tone/SQ adjustable range: 12 dB to 12 dB (by 2 dB)
SQ Low/Bass: ±12 dB (at 60 Hz, 80 Hz, 100 Hz,
200 Hz)
SQ Mid: ±12 dB (at 500 Hz, 1 kHz, 2 kHz,
3 kHz)
SQ High/Treble: ±12 dB (at 8 kHz, 10 kHz, 12 kHz,
15 kHz)
• The bass/treble control level of each frequency is fi xed
to the frequency that has been selected for SQ.
To return an adjusted SQ to the default setting
 Press [SQ], and select the SQ which is to be returned
to the default setting. (Only for main unit)
 Hold down [BAND] for 2 sec. or more.
(FLAT) fl at frequency response:
does not emphasize any part. (Default)
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.
(VOCAL) clear sound:
emphasizes middle tone and slightly
emphasizes treble.
(JAZZ) jazz-specifi c deep sound:
sound with emphasis on sharpness of high-
hat and echo saxophone.
(CLUB) club and disco-specifi c sound:
reproduction of realism being in a club.
1
Press [VOL] (PUSH SEL:
Select) to open the menu.
2
Press [VOL] (PUSH SEL: Select) to
select a mode to be adjusted.
3
Adjust each band.
/: center frequency up/down
[] []: Band selection
[] []: Level up/down
Band
Level
Frequency
4
Hold down the numeric button [2] to [6]
for 2 sec. or more.
• The adjusted SQ is preset in the number of the selected
button, and return to the regular mode resumes.
• When you suspend the SQ preset adjustment, each level
remains your recent adjustment until a new SQ presetting
operation is performed or you call up the SQ preset.
Notes:
• You cannot save any SQ presetting value in [1] button.
• Any SQ adjustments will not change the call up screen
names such as ROCK and JAZZ.
• Do not activate SQ and Bass/Treble at the same time to
avoid causing sound distortion.
13
CQ-C5405U/C5305U